Systec DX-45 Autoclave

Systec DX-45 belongs to the Systec D-series of horizontal table-top autoclaves: these autoclaves don’t just look different. They are also different. Specially developed for the special sterilization tasks in the laboratory, they make the processes safe, accurate, reproducible and validated.

Integrated, separate steam generator

Internal heating elements within the autoclave chamber

Housing, support frame and pressure vessel made of corrosion-resistant stainless steel

Temperature and pressure range 140°C, 4 bar absolute pressure

LCD display and fully automatic microprocessor control

Up to 25 sterilization programs

Code-secured access rights for changing parameters and further safety-relevant intervention

Internal memory for storing up to 500 sterilization cycles

Timer for starting programs

Autofill: automatic demineralized water feed for steam generation

Flexible PT-100 temperature sensor

Additional temperature sensor in condense exhaust

Temperature holding function for liquids after program finish

Special program for Durham tubes

Calculation of F0 value

Special program for waste sterilization with pulsed heat-up for more efficient air exhaust

Water-cooled steam exhaust, thermostatically controlled

Programmable automatic door-opening on completion of program

Required connections:

Tap water: ≥ 1bar water pressure (alkaline earth ions ≤ 2,0 mmol/l, conductivity max. 300 µS/cm, 11°dH, 200mg/l CaCO3)

Demineralized water: ≥ 1bar water pressure (alkaline earth ions < 0,02 mmol/l, conductivity 0.1 – 15 µS/cm)

Compressed air: min. 3 – 10 bar, 50 l/min

Dimensions (HxWxD): 585 x 620 x 755 mm

Chamber dimensions (ØxD): 344 x 500 mm

Chamber volume: 45 L